2014.07 Dioxide

PET recycling processes for food contact materials: EFSA adopts first opinions

2012-08-07 add to your clipboard

PET recycling processes for food contact materials: EFSA adopts first opinions The three opinions adopted by EFSA’s Panel on Food Contact Materials, Enzymes, Flavourings and Processing Aids (CEF) assess a total of ten recycling processes, grouped according to the applied recycling technology. Among the Panel’s conclusions for all three opinions, it stated that the recycling processes would not give rise to safety concerns if the proportion of PET from non-food consumer applications does not exceed 5 %, and these processes are operated under well-defined conditions. The Panel recommends that this is monitored periodically in line with Good Manufacturing Practices (GMP).

EFSA evaluations only concern the safety of mechanical recycling processes, in which used consumer plastics are collected, ground into small flakes and decontaminated, before being processed into new materials for use in the food chain. Collected plastics used in mechanical recycling might have been previously contaminated with chemicals that are not suitable for food contact applications. Producers are required to demonstrate that their process can reduce chemical contaminants in the recycled plastic to such a level that potential migration of any residual chemicals does not pose a risk for human health.

In 2011, the CEF Panel published an opinion describing its safety assessment approach for PET recycling processes, specifying the evaluation criteria it uses. In its safety assessment, EFSA takes into account the quality of the input materials, the efficiency of the process to decontaminate the plastics and the intended use of the recycled plastic. In addition, the process steps that are critical for ensuring sufficient decontamination must be identified and their operation must be described. Where necessary, applicants may be required to modify the proposed uses and/or modify the proportion of recycled material to be in compliance with EFSA’s scientific methodology.

These three opinions are the first opinions of a series to be issued over the next 18 months on applications for recycling processes to manufacture plastics for food contact materials. In line with its Founding Regulation, EFSA publishes its opinions in a timely manner as they are adopted. The sequence of publication of opinions on these processes is linked to EFSA’s work programme set up on the basis of the applications received. Therefore, the publication of these opinions should not be seen as an order of priority, or in any way reflect on the quality of processes which EFSA has not yet evaluated for safety. An overview of all applications for authorisation received can be accessed on EFSA’s website: Register of Questions

The three adopted scientific opinions on the safety evaluation of the following PET recycling processes used to recycle post-consumer PET into food contact materials are presented below:

  • Four recycling processes based on VACUREMA Prime technology
  • Five recycling processes based on Starlinger IV+ technology
  • Recycling process “PETUK SSP”

  • Read more: RPET [4]